I've seen a few of these threads so I decided to turn it into a step by step pictorial.
Moderators delete if you see fit.
Throw "One Shot" in the garbage because evdentially it sucks...
Gather contents -
Liquid Lanolin (100% pure was $7.00 at the local health food store)
Isopropyl Alcohol (at minimum 91% $1.19 at the local drug store - 99% is best couldn't find it)
New or Clean spray bottle (from the "Dollar" store) has ratio markings and ounce markings so it helps
Warm the Lanolin in warm tap water (110 to 120 degrees F - NO OPEN FLAMES)
Do the same for the IPA, this will help in the mixing process.
Pour 2 (two) ounces of the warmed Lanolin into the spray bottle
Pour 16 (sixteen) ounces of the warmed IPA into the spray bottle giving you an 1:8 ratio
This seem to be the ratio that best mimics Dillon Spray Lube
Shake until contents becomes homogonized and label the bottle accordingly (so you don't confuse it with CLP or something)
then proceed to lube cases as needed. I left some room incase I needed to adjust the ratio depending on the dies and how finiky they may be. Seems to work fine. I did about 30 once fired LC headstamps and it was smooth as silk.
Hope it helps